Classic AutoAir Perfect Fit-Elite Series Instruções de Operação descarregar pdf (Página 19)

Caution: Carefully check under the Instrument Panel for all cables, electrical harness, or Flex

hoses that might interfere with the safe operation of the vehicle.

Locate the Water Valve and (3) worm gear clamps.

Attach the Temperature cable to the water valve using the

cable clip supplied on the water valve.

Supply line from the engine is attached to the left heater

hookup tube. Cut 6” off end of the return line and install

the water valve using (3) worn gear clamps as shown

above.

Note: It is recommended that you replace heater hoses

from the engine to the hookup tubes.

Installation of the interior components is complete. We will now install the

under hood portion of the system.

There needs to be a 1” hole for the

discharge tube to come through the

radiator support.

Locate on the passenger side of the

radiator support. The center of the hole to

be drilled. Drill a 1” hole to the

dimensions as shown.

Locate the Receiver Drier, Drier Mounting Bracket,

Aluminum Liquid tube, (2) #6 o-rings, and (2)

#10 x 3/8” hex head screws.

Install the Receiver drier to the condenser as to

allow the Liquid Tube to attach as shown.

5/8”

6 7/8”

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 30 31

Sem comentários

Classic AutoAir Perfect Fit-Elite Series Instruções de Operação Página 19