Classic AutoAir Perfect Fit-Elite Series Instruções de Operação descarregar pdf (Página 14)

The shortest heater hose attaches to the fitting on left using (1) of the worm gear clamps.

Locate the evaporator, (1) 1ft of 2” diameter flex duct, (1) 2ft. of 2” diameter flex duct, and (2)

ty-raps.

Place unit on bench and attach the 2ft duct to the left hose adaptor using (1) ty-rap.

Attach the 1ft duct to the right hose adaptor using (1) ty-rap. As shown in picture on next page.

The next step is to install the evaporator into the car. The picture to

the right shows the unit from the front. Note the 2ft duct lays over the

top of the unit as it is installed.

Lift unit up and behind the instrument panel. The picture on next page

shows the engine side of the firwall. The (2) studs insert into the

original heater mounting holes. Attach using (2) ¼”-20 flange nuts

provided in the hardware sack kit.

Attach th flex duct from the heater outlets to the

distribution assembly. As shown.

Locate in the kit (1) 2ft 2” diameter flex hose and

(1) 2” diameter flex hose.

Attach the 2ft hose from the left defrost outlet to

the drivers side defrost diffuser. Attach to diffusser

using (1) #8 x 3/8” pan head screw.

2 ft flex duc

1 ft flex duc

1ft DUCT HOSE

2FT DUCT HOSE

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 30 31

Sem comentários

Classic AutoAir Perfect Fit-Elite Series Instruções de Operação Página 14